top of page

TST 453

Our 453 bbl complete mixing system provides our customers with the ultimate OBM, SBM or WBM plant. This system is mounted on a single axle (25k lbs) chassis that can be delivered to your site via a standard over-the-road truck, savings costly specialized transportation that requires oversize permits. A separate multi-functional pre-wired pump skid can be connected and fully operational in only a few hours after delivery.



  • 400 bbl. mixing capacity with a 53 bbl buffer

  • 1/4 carbon steel tank shell for optimal fluid movement, coated with “Duraplate UHS” protective liner for lasting protection

  • Rear stairs with full length 6’ catwalk

  • Obstruction free interior for undisturbed mixing

  • Fluid return lines to rear of tank and eight (8) staggered roll line nozzles for maximum sweep of the entire tank to eliminate all dead spots 

  • Four (4) 60HP High Shear Turbine Heads

  • Two(2) 8 X 6 X14 Mission Magnum Centrifugal Mud Pumps

  • Pumps can be operated separately or in tandem

  • Unique Manifold System allows for the pumps to operate the mix tank, serve as transfer pumps,  product load-out, or roll storage tanks  independently or simultaneously

  • Pumps are powered by two (2) 100HP explosion proof motors prewired to an explosion proof control panel equipped w/ABB soft-start controllers and generator or hard line ready

  • Two (2) 2” valved connections for emulsifiers/wetting agents or mixing components for immediate introduction into the fluid stream

  • Two (2) 8” suction connections for inline frac tank hook up or oil and water 
    supply tanks

  • Large capacity induction hopper for dry products

  • Integrated thermometer for tank temperature monitoring

bottom of page